This loom has been 3D printed from PLA filament and is fantastic for weaving small projects.
Overall size is approximately 17cm x 24cm and the weaving space is approximately 12cm x 16.5cm.
You could weave a hanging tapestry, mug coaster, pouch...
No yarn is included with this loom but why not pick up some funky yarns to play with from here. We also have tapestry needles here.
Imperfect prints are those with slight blemishes. Please see the last pictures for the measurements of the loom. These red looms are imperfect because of the paw prints, please see the pictures for a close up of these.
I have written instructions on how to use your loom here.
Please avoid placing your tools too close to a heat source such as a radiator or in direct sunlight as this can cause warping. We sand these tools down by hand to prevent sharp edges that could snag your fibre and you may see evidence of this. Occasionally our prints may have non visible defects that cause weakness. Please message us if you have any issues, we are always here to help!
Please allow for differences in colour due to varying screens.
