Pink - Extender For Niddy Noddy - Extends it to 2 yards - Flat Pack
This is the extender part ONLY to fit my PLA 3d printed niddy noddies. This will extend your niddy noddy from 1 yard to 2 yards. What you will receive with this listing are the 2 middle sections to extend your niddy noddy for 9" to 18" in length.
This tool is for wrapping your yarn around to create a skein. If you wrap your yarn too tight around our niddy noddy, you will find it difficult to remove the yarn as the outer lip is raised and you will also not get an accurate gauge of the length of your yarn because you will have stretched it so much while on the niddy noddy. If you have any questions about how to use your item please do message us. We want to help make your spinning life easier!
Please avoid placing your tool too close to a heat source such as a radiator or in direct sunlight as this can cause warping.
We sand these tools down by hand to prevent sharp edges that could snag your fibre and you may see evidence of this. Occasionally our prints may have non visible defects that cause weakness. Please message us if you have any issues, we are always here to help!
Find the matching niddy noddy here.
Find a walkthrough of how to use our 2 yard niddy noddies here.
Please allow for differences in colour due to varying computer monitors.
This extender was originally designed by Sarah at Strange Printz but altered by Hairy Dog Crafts.