Melon Yellow - Yard Niddy Noddy With WPI Gauge - 3D Printed
This listing is for a 3D printed niddy noddy. It is printed using PLA and is perfect as a travel niddy noddy as it pulls apart and packs flat.
Please allow for differences in colour due to varying computer monitors.
It is very light and the dimensions are (when assembled) 22.5cm long and each part separately measures 16.5cm long by 14.5cm wide.
This tool is for wrapping your yarn around to create a skein. If you wrap your yarn too tight around our niddy noddy, you will find it difficult to remove the yarn as the outer lip is raised and you will also not get an accurate gauge of the length of your yarn because you will have stretched it so much while on the niddy noddy. If you have any questions about how to use your item please do message us. We want to help make your spinning life easier!
Please avoid placing your tool too close to a heat source such as a radiator or in direct sunlight as this can cause warping.
We sand these tools down by hand to prevent sharp edges that could snag your fibre and you may see evidence of this. Occasionally our prints may have non visible defects that cause weakness. Please message us if you have any issues, we are always here to help!
It will make a 1 yard skein.
I have a handy video walkthrough of how to use our 1 yard niddy noddies here.
I have an extender available here to make this into a 2 yard niddy noddy.